Turning On The Monitor; Settings; Selecting The Area - Sony BVMF170A Operation Manual

over the DC power supply. To use the DC power supply,
disconnect the AC power cord.

Turning on the Monitor

Press the MAIN POWER switch on the rear panel to turn
on the power.
When you turn on the monitor for the first time after
purchasing it, the Select Area screen is displayed. Select
the area where you intend to use this monitor.
For selecting the area, see page 33.
The warm-up time is more than 30 minutes, approximately.
When the monitor is in standby mode
As the OPERATE lamp lights in red in standby mode,
press the MONITOR I/1 switch of the controller.
The OPERATE lamp lights in green and the monitor enters
operation mode.

Settings

Selecting the Area

When you turn on the monitor for the first time after
purchasing it, select the area where you intend to use this
monitor from among the options.
When the area is selected, the menu item settings suitable
for the selected area are applied.
Default value for each area
5
4
3
3
Color
Temp
1North America D65
2Latin America
Argentina D65
PAL&PAL-N
Paraguay D65
Area
Uruguay D65
NTSC&PAL-
Other Area D65
M Area
3Africa
Australasia
D65
Europe
Middle-East
NTSC Area D65
4Asia Except
Japan
PAL Area D65
D93
5Japan
Note on the setting of color temperature
If you measure the color temperatures of different display
types, such as CRT, LCD, or OLED, by using a common
(or general) color analyzer that is based on CIE 1931, and
adjust the xy chromaticity to the same value, the
appearance may be different because of optical spectrum
differences.
3
1
2
Setup Component Color
Level Level Profile
ITU-R
7.5% Betacam
BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
ITU-R
7.5% Betacam
BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
ITU-R
7.5% Betacam
BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
SMPTE/ ITU-R
0%
EBU-N10 BT.709
33
Settings