Start Of Call - IBM Infoprint 6500-v05 Maintenance Manual

Chapter 1

Start Of Call

Start Of Call

Are you here because of an
YES
error message?
NO
Power on the printer and
observe the operator panel for
the following sequence of
events (retry as required):
1. All black squares appear on
the display.
2. Display goes blank.
3. The following messages
appear on the display, in this
order:
B00 STATUS: SDRAM
DETECTION 33MHZ
B01 STATUS: 8245
SDRAM TEST 32MB
B51 STATUS: XX%
LOADING
B30: STATUS INITIALIZING...
YES
Did steps 1, 2, and 3 occur?
NO
Did the fans come on after 10
seconds?
YES
NO
Go to Troubleshooting Display
Messages, page 42.
Did the status
lamp come on
and READY
appear on the
display? (If
default is NOT
After about 10
READY, status
YES
seconds did the
lamp will not
fans come on ?
come on.)
NO
NO
Go to Printer does not
complete IML, page 185.
Press STOP.
Press CONFIG.
Go to the Operator Panel
Press START.
YES
section of Table 5, page
Does machine
176
configuration print?
NO
The Operator Panel is
not functioning (Table
5 page 176)
—OR—
Printer does not
complete IML, page
185.
IML was
successful.
Other
YES
symptoms are
listed in Table
5, page 176.
Did ANY of steps 1 thru 3
Are there black
occur?
YES
squares on the
NO
operator panel?
Go to No power, and
operator panel is blank,
Go to Printer does not
and card cage fan is not
complete IML, page 185.
running, page 184.
Go to Black
YES
squares on
operator panel
display, page
NO
180.
40