IBM Infoprint 6500-v05 Maintenance Manual page 340

TN
X
X
* This is also the Base ASCII-only security key
Installation
1. Put on a static wrist strap and ground the lead to an unpainted part of the printer frame. Touch the printer frame with the
hand wearing the wrist strap before you touch memory modules or the controller board.
2. Position the security key on controller board connector J9 so that the lock indentation is on the same side as the locking tab
on connector J9. Gently press the security key down onto the pins until the locking tab engages the lock indentation and
locks the key in place. (See Figure 18.)
NOTE: Installing flash memory from one controller board to another does not transfer all operating system software, so you
must download the emulation again.
3. Insert the flash SIMM into socket J11 on the controller board at about a 45 degree angle. Position the flash SIMM with the
notched end toward the right side of the controller board. Press the SIMM gently into the socket until the edge connectors
are seated, then press the SIMM downward until the side latches lock the SIMM is place. (See Figure 18, page 341.)
4. Cabinet Model: Install the paper guide assembly (page 348).
Pedestal Model: Install the top cover assembly (page 327).
5. Download the emulation (page 231).
6. Return the printer to normal operation (page 314).
7. Using the configuration printout(s) you made in step 1 of the removal procedure, reset and save the printer configuration(s).
(Refer to the Setup Guide.)
Code Loads
ANSI CT Code V / IGP
X
X
Memory Modules and Security Key
Part Number
IPDS
39U2464
39U2467
39U2468
340