Controls And Indicators; Electrical Controls: Figure 5 - IBM Infoprint 6500-v05 Maintenance Manual

Controls And Indicators

Electrical Controls: Figure 5

Key or Indicator
MENU
CONFIG
RETURN
MICRO ↑
MICRO ↓
SCROLL ↑
SCROLL ↓
ENTER
LINE FEED
VIEW
FORM FEED
SET TOP
OF FORM
CANCEL
EJECT
STOP
If the printer is in NOT READY mode, this key puts the printer into PROGRAM mode. If the
configuration menus are locked, the LCD indicates the operator panel is locked.
Prints the current configuration.
Returns to the next higher level of a configuration menu.
In NOT READY mode, moves the paper upward 1/72 inch ("micro-step" function).
In NOT READY mode, moves the paper downward 1/72 inch ("micro-step" function).
In PROGRAM mode, moves to the next menu ("Scroll" function).
In PROGRAM mode, moves to the previous menu ("Scroll" function).
Selects the option displayed on the LCD. This action either sets a value, moves to the next lower
level of configuration, or starts a self-test.
Moves paper up one line, as determined by current line spacing.
Press to move the current print position up to the tractor area for viewing. Press again to return
paper to original print position.
Advances paper to next Top-Of-Form, as defined by the current page length.
Sets Top-Of-Form and moves paper downward from the tractor alignment notches to the print
position.
Cancels a print job.
Moves paper for viewing or tear-off. This key is configurable: refer to the User's Manual.
Puts the printer in NOT READY mode. This key also stops a Printer Test, and restores after an
eject.
Electrical Controls: Figure 5
Function
34