Selecting And Running Ce Tests - IBM Infoprint 6500-v05 Maintenance Manual

Selecting And Running CE Tests

To run CE Tests you use the printer configuration menus, as shown below:
Step Press
1. Load paper and power on the printer.
2. STOP
3. MENU + SCROLL↑ +
CONFIG + SCROLL↓
4. ENTER
5. SCROLL↑ until
6. RETURN + ENTER
7. ENTER
8. STOP or START
Displayed Result
NOT READY
SERVICE
PRINTER MECHANISM TESTS
PRINTER MECHANISM TESTS
Burn In Test
PRINTER MECHANISM TESTS
Plot Test
OPERATOR MENU
UNLOCKED
Plot Test
Running
NOT READY
Selecting And Running Tests
Notes
Printer must be in NOT READY mode to access
the tests.
Press all four keys at the same time.
Press ENTER to view the different mechanism
tests.
Cycles through list of tests. Stop when your test
displays.
Unlocking ENTER key allows you to test the
printer.
The test you selected starts printing. See
Chapter 6 for instructions in the use of the
Hammer Phasing and End of Forms Adjust tests.
STOP halts the test, exits the menu, and puts the
printer in the NOT READY state. START halts
the test, exits the menu, and puts the printer in
the READY state.
220