Introduction - IBM Infoprint 6500-v05 Maintenance Manual

Appendix E

Introduction

Introduction
The SureStak** Power Stacker is a factory-installed option for high speed cabinet model printers that mechanically directs the
paper from the print area to the paper stack. The power stacker is mounted in the rear of the cabinet and has its own operator
panel. It is designed to work with forms from 5 to 12 inches (12.7 to 30.5 cm) long. Using longer or shorter paper can cause
error messages and unpredictable behavior of the stacker. The power stacker can handle forms from 3 to 16 inches (76 to 406
mm) wide with no paper tent in the pull-out tray, and from 3 to 15.5 inches (76 to 394 mm) wide with the paper tent installed in
the pull-out tray.
IMPORTANT
Access to the stacker assembly is restricted while it is in the cabinet. You must remove the stacker assembly from the
printer to service it.
This appendix has three sections:
•
How to operate the power stacker.
•
Removal/installation instructions for the stacker assembly and components that require the most frequent replacement.
•
An illustrated parts breakdown (IPB) showing how the power stacker is assembled and listing the part numbers for
replaceable parts.
NOTE: Only replaceable parts have part numbers in the IPB. If you need to replace a part for which no part number is shown,
replace the entire power stacker assembly.
452