IBM Infoprint 6500-v05 Maintenance Manual page 139

Operator Panel Message
306 UNKNOWN RIBBON
INSTALL NEW IBM RIBBON
307 UNKNOWN RIBBON
INSTALL NEW IBM RIBBON
308 RIBBON SENSOR ERROR
SEE USERS MANUAL
990 MACHINE CHECK
A97 GRAPHIC CHECK ERROR
PRESS STOP THEN START
B00 STATUS: SDRAM
DETECTION 33MHZ
B01 STATUS: 8245
SDRAM TEST 32MB
B10 ERROR:
NO DRAM DETECTED*
B11 ERROR:
RAM TEST FAILED*
B12 ERROR:
PROGRAM MISSING*
B13 ERROR:
NOT COMPATIBLE*
Table 3. Message List
Explanation
The sensor detects a bar code,
but the OEM ribbon model is not
permitted on this printer.
The sensor detects a bar code,
but the region code does not
match the printe
A future enhancement not
supported on this printer.
Host status message.
The printer received a non-
printable character over a twinax
interface.
Status message: the printer has
begun its boot-up initialization
routines and is checking for the
presence of SDRAM.
Status message: printer boot-up
routines are testing SDRAM.
Boot-up routines did not detect
the presence of the SDRAM
DIMM.
SDRAM failed the boot
initialization test.
The printer does not see a
program in flash memory.
The printer is not compatible with
the downloaded program.
Corrective Action
Install a new IBM ribbon.
Install a new IBM ribbon.
No action required.
No action required.
Press STOP then START.
No action required.
No action required.
Cycle power. If the message appears, replace the controller board.
Record the message and return it with the defective board.
Cycle power. If the message appears, replace the controller board
(page 319). Record the message and return it with the defective
board.
There is no program in printer memory. Download an emulation.
Load the correct emulation software option(s) for this printer.
Display Messages
139