IBM Infoprint 6500-v05 Maintenance Manual page 247

Message
ERROR: SECURITY KEY
NOT DETECTED
(continued)
ERROR: SHORT AT Hardware failure in SDRAM or controller circuitry.
ADDRESS XXXX
ERROR: WRITING Hardware or software fault in flash memory.
TO FLASH
ERROR: WRONG The printer received the complete program but the
CHECKSUM checksum did not match. The data were corrupted
during download.
ERROR OCCURRED An interim message that displays while the printer
FLUSHING QUEUES* discards host data it cannot use because a fault
condition exists. While this message displays, the
asterisk (*) rotates.
LOADING PROGRAM The new program is loading into printer RAM. XX
FROM PORT XX% indicates how much of the program has loaded.
LOADING PROGRAM The printer has deleted the previous program from
INTO FLASH flash memory and is loading the new program into
flash memory.
RESETTING . . . The printer finished loading the program into flash
PLEASE WAIT memory and is automatically resetting itself.
Table 6. Flash Memory Message Guide
Explanation
Loading Through The Serial Or Parallel Port
Required
Action
7. Power on the printer in download
mode and load flash memory
(page 238).
8. If you encounter the failure after
replacing the controller board,
reinstall the original controller
board and contact your DDS and
Second Level Support.
Cycle power. If the message appears
again, replace controller board.
Download the program again: Power
off the printer and start over at step
11. If the message occurs again,
replace the flash memory.
Download the program again: Power
off the printer and start over at step
11.
Wait. When the asterisk (*) stops
rotating, a different fault message will
appear: troubleshoot the final
message.
None
None
None
247