Paper Ironer - IBM Infoprint 6500-v05 Maintenance Manual

Paper Ironer

<2> Over time the upper edge of the paper ironer can become sharp. To avoid cutting yourself, handle the
paper ironer on the sides.
CAUTION
Removal
1. Remove the shuttle frame assembly (page 362).
2. Open the forms thickness lever.
3. Push the ends of the paper ironer toward the rear of the printer, disengage the tabs, then lift it up and out (page 413, Figure
45, item 3).
4. 6500-v15 and 6500-v20 models only: remove the auxiliary paper ironer, which is directly in front of the standard paper
ironer
Installation
NOTE: The black tape on the paper ironer faces the paper detector switch assembly (toward the front of the printer).
1. Position the paper ironer so that the black tape is on the side that faces the paper detector switch assembly. (See page
413, Figure 45, item 3.)
2. Push the paper ironer down into the slots until the tabs engage.
3. 6500-v15 and 6500-v20 models only: install the auxiliary paper ironer in front of the standard paper ironer. (See also the
NOTE on page 413, next to item 3.) Make sure the tabs on both paper ironers are firmly engaged.
4. Install the shuttle frame assembly (page 362).
5. Return the printer to normal operation (page 314).
Paper Ironer
349