IBM Infoprint 6500-v05 Maintenance Manual page 241

Message
CLEARING PROGRAM The program successfully loaded into printer RAM and
FROM FLASH the checksum matched. The old program is now being
deleted from flash memory.
DIAGNOSTIC The printer passed its memory and hardware
PASSED initialization tests.
ERROR: DC PROGRAM Printer cannot find the data controller program or the
NOT VALID validation checksum is corrupted.
ERROR: DRAM AT The printer found a defective memory location.
ADDRESS XXXXXXXX
ERROR: EC PROGRAM Printer cannot find the engine controller program or the
NOT VALID validation checksum is corrupt.
Table 6. Flash Memory Message Guide
Explanation
Loading Through The Serial Or Parallel Port
Required
Action
None
None
Download the program again: Power
off the printer and start over at step
11. If the message occurs again,
replace the flash memory.
Replace the controller board.
Download the program again: Power
off the printer and start over at step
11. If the message occurs again,
replace the controller board.
241