IBM Infoprint 6500-v05 Maintenance Manual page 481

24. Install finger tight the 10-32 x 5/32 inch buttonhead screw and washer securing the left vertical rail to the upper frame
cross-member. (Do not install the right hand screw yet.) (Figure 78.)
25. Install and tighten the two Torx T-10 screws securing the stacker base to the cabinet floor. (Figure 78.)
26. Install and tighten the two Torx T-10 screws that secure the rail bracket to the cabinet floor. (Figure 78.)
Left Screw, 10-32 x 5/32 inch
Screw,
Torx T-10
(2 places)
Rail Bracket
Figure 78. This figure shows which screws to install to secure the stacker assembly in the rear of the cabinet.
Right Vertical Rail
Upper Frame
Cross-Member
Left Vertical Rail
Washer
Washer
Right Screw, 10-32 x 5/32 inch
Screw, Torx T-10
Stacker Base
Screw,
Torx T-10
481