IBM Infoprint 6500-v05 Maintenance Manual page 132

Operator Panel Message
173 ERROR: WRONG
CHECKSUM
Table 3. Message List
Explanation
The printer received the complete
program but the checksum did not
match. The data may have been
corrupted during download.
Corrective Action
1. Power off the printer. Download the program again from the
beginning. If the message appears, download the latest code
from IBM First (page 231). If the message appears, replace the
flash memory with blank flash containing boot code.
2. Load flash memory (page 238).
3. If the message appears, the controller board or microcode is
suspect. Do the following:
4. Save the printer configuration values. (Refer to the User's
Manual .)
5. Clear NVRAM (page 237).
6. Download and install the latest code from IBM First (page 231).
7. Power on the printer in download mode and load flash memory
(page 238).
a. If you encounter loading problems, go to the appropriate error
code for resolution.
b. If you encounter the failure or message that brought you to
this procedure, replace the controller board (page 319). After
replacing the controller board, DO NOT make the printer
READY, but proceed immediately to the next step.
8. Download and install the latest code from IBM First (page 231).
9. Power on the printer in download mode and load flash memory
(page 238).
10. If you encounter the failure after replacing the controller board,
reinstall the original controller board and contact your DDS and
Second Level Support.
Display Messages
132