Setup Controls; Menu's And Parameters - IBM LB20 User Manual

3.1.2

Setup Controls

These are:
Button Bar providing three functional periods of operation:
Press down and release in less than one second (Hit)
Press down and release after two seconds
Press down and hold down until the engine runs and the document moves,
then release
3.1.3

Menu's and Parameters

On entering Setup, you are prompted to Select a Menu or Quit the Setup. Menu's
are Selected or Quit from the start and end point, QUIT OR SELECT. Printer
Settings are printed from the VIEW point. Thus, the structure is :
Note: The COM menu is not used or shown in a Parallel Printer.
The Parameter's in each Menu for a Serial Printer are:
COM IBM
Baud rate Country
Length Set
Stop bits Font
Parity CPI
Flow ctrl LPI
Condensed
CR=>LF
LF/VT=>CR
Form Length
Zero
Top Margin
Setup
QUIT OR SELECT
COM Menu
IBM Menu
DOC Menu
<>DFT Menu
<>HQD Menu
VIEW
DOC <>DFT
Cover offset Draft coarse
Horz psbk seam Draft fine
Psbk range
Psbk width min.
Psbk seam type
Top offset
Psbk smudging
Form smudging
Print contrast
<>HQD
HQD coarse
HQD fine
3-2