Pulse Speed Selection - Panasonic KX-TD308 Installation Manual

Outside Line Programming
4 6
Description
Selection
Default
Programming
Conditions
Feature References

Pulse Speed Selection

An outside line set for pulse or call blocking mode in program
and 20 pps (high). This program sets the pulse speed for each
outside line set to pulse or call blocking mode.
Outside line (CO) number: 1 through 3, * ( * =all outside lines)
l
. lOpps/2Opps
All outside lines - 10 pps
1.
Enter 403.
Display: 403 PULSE SPEED
2. Press NEXT.
Display: CO Line NO?+
3. an outside line number.
Enter
To enter outside line number 1, you can also press
Display example: CO1:lOpps
Keep pressing SELECT
4.
displayed.
5. Press STORE.
6.
To program another outside line, press
SELECT and the desired outside line number.
7.
Repeat steps 4 through 6.
8. Press END.
To assign all outside lines to one selection, press the * key in step 3.
l
In this case, the display shows the contents programmed for outside line
1.
Tbe pulse speed required is determined by the CO or PBX line.
l
Program [990] "System Additional Information, Field (17) and Field
l
(21)" are used to select a pulse break ratio and inter-digit pause, if
needed.
Section 3, Features
Dial Type Selection
NEXT.
until the desired selection is
NEXT or PREV, or
System Programming
4-97