User Programming - Panasonic KX-TD308 Installation Manual

4.1.4 User Programming Mode
Entering the user programming mode
Note
4-12 System Programming
Some programming items are accessible by any display proprietary
telephone user in the system.
The programming items are listed below:
You can access these programs by entering the User Programming
Mode as follows:
Before entering the mode, confirm that:
Your telephone is on-hook.
l
No calls are on hold at your telephone
l
Press PROGRAM (or PAUSE)
Password (default: 1234)
After entering the mode, perform the same programming steps as
the system programming steps in each program address.
If your telephone set does not have a PROGRAM button, substitute it
l
with the PAUSE button.
If nothing is entered in five seconds after the PROGRAM (or PAUSE)
l
button is pressed, it is cancelled.
The User Password is not shown on the display. The password can be
l
changed by system programming. Refer to Section 4.3 [ 1201 "User
Password".
During the programming mode, your extension is treated as a busy
l
extension.
Only one proprietary telephone can be in programming mode at any one
l
time.
+ * + * and enter the User