Vm Command Dtmf Set - Panasonic KX-TD308 Installation Manual

Description
4-46
System Programming
4 3 0 System Programming

VM Command DTMF Set

Sets the DTMF command signals transmitted to your Voice
Processing System (VPS). There are four commands available:
Leave Message; Get Message; Automated Attendant Service; Voice
Mail Service. These commands are used in the following ways:
(A) If your VPS is used for Voice Mail (VM) Service
If a call is forwarded to the VPS, your system will send a mailbox
number to the VM port. This allows the caller to leave a message
without knowing the mailbox number.
Required entries (selections):
l
LV-MSG
(Leave Message): This command is transmitted to a
VM port if a call is forwarded or intercepted and rerouted to the
port.
AA-SVC
(Automated Attendant Service): If AA Service is set to
"Start" in program [990], field (lo), the "AA-SW" command is
sent to a VM port if an incoming outside call is answered by the
VM port.
Other programming required (program addresses): [ 1061; [602];
l
field (10); [990], field (18)
If the VPS receives a message and lights the MESSAGE button
indicator of the dialed telephone, the telephone user can hear the
message by pressing the MESSAGE button.
Required entries (selections):
l
GETMSG
(Get Message): This command is transmitted to a VM
port when the message receiver presses the MESSAGE button.
VM-SVC
(Voice Mail Service): The "VM-SW" command is a
code transmitted preceding the "GETMSG" command above.
This is effective to switch to VM port when an AA port lights the
MESSAGE indicator.
Other programming required (program addresses): [609]; [990],
l
field (18)
An AA port answers an incoming outside call to provide AA
services, such as call transfer, receiving a message.
Required entries (selections):
l
VM-SVC
(Voice Mail Service): The "VM-SW" command is a
code transmitted before the "LV-MSG" code if an operator
transfers a call to an extension and then it is forwarded to an AA
port so that the AA port can be switched to the VM port
temporarily.
Other programming required (program addresses): [ 1061, [602]
l