Entering The Programming Mode - Panasonic KX-TD308 Installation Manual

4.1.1 Using Proprietary Telephones
Viewing the Display
Before entering the programming mode

Entering the programming mode

Note
System Programming
4-6
The display gives you helpful information, such as what you should
do now, what you have done, etc..
The RX-T7230 and the KX-T7235 both utilize two information
lines for programming. The upper line is called the Message Line
and the lower one is called the Function Line.
The Message Line (upper) shows you what you should do or what
you should select. It also allows you to confirm what you have just
entered. The display capacity is 16 digits. If your entry exceeds the
capacity, you can shift the display by pressing e or + button.
The Function Line (lower) shows the current function of the soft
buttons. These functions change with the programming procedures.
Before entering programming mode, confirm that:
Your telephone is on-hook.
l
No calls are on hold at your telephone.
l
PROGRAM
Press (or
Password (default=1234).
The display shows the Initial Message: SYS-PGM NO? +
l
If
your telephone set does not have a PROGRAM button, substitute it
l
with the PAUSE button.
If nothing is entered in five seconds after the PROGRAM (or PAUSE)
l
button is pressed, it is cancelled.
l
Password can be changed by System Programming. Refer to Section
4.3 [ 1071 "System Password'.
During the programming mode, your extension is treated as a busy
l
extension.
Only one proprietary telephone can be in programming mode at any
l
one time.
PAUSE) + * + #
and enter your
System