To Configure Each Server In A Stack - Alcatel-Lucent OmniTouch Administration Manual

System Configuration
............................................................................................................................................................................................................................................................
After physically configuring the servers, and going through the steps documented earlier to
set up IP addresses and other server-specific settings, do the following for each server in
the stack.

To configure each server in a stack

........................................................................................................................................................................................................................
Click the
1
........................................................................................................................................................................................................................
Click the
2
........................................................................................................................................................................................................................
In the resulting window (below), enter:
3
– The
– The
– The
Note:
which use one digit for the
to
servers (primaries and secondaries) in a stack. Because media servers do not store
conferences, you can still have up to 99 of them in a stack even though six digit Access
Codes are specified.
If using remote sites which are bridged together using PSTN, enter the telephone
number (Stack Phone for Remote Sites) used by remote OmniTouch ACS sites to
bridge together distributed conferences (the phone number other sites call to bridge
their servers to this site's servers).
........................................................................................................................................................................................................................
Select whether this server is to be an
4
the OmniTouch My Teamwork Unified Conferencing and Collaboration Application Site
Preparation Guide for a complete explanation of Application and Media Servers.
............................................................................................................................................................................................................................................................
8AL90208USAD ed01
November 20, 2008
tab.
Configuration
item.
Stacking
Stacking method
(all servers use the same stack name)
Stack Name
for the specific server you are configuring. This should be a two-digit
Node ID
number that will become the first two digits of users' conference access codes.
Zero (0) is not a valid
s one (1) to nine (9). This results in a maximum of nine (9) application
Node ID
( or )
Dynamic Static
for a server in a stack. If six-digit access codes
Node ID
are to be used, the application servers are limited
Node ID
Application Server
To configure each server in a stack
, a , or both. See
Media Server
2 - 7 7