Alcatel-Lucent OmniTouch Administration Manual page 126

System Configuration
............................................................................................................................................................................................................................................................
b. Locate the box labeled
c. Click the
d. A TightVNC window (virtual machine) should appear. If you do not see a
........................................................................................................................................................................................................................
Initialize a new VMware virtual machine on the OmniTouch ACS and automatically
3
install Windows XP Professional and Office 2007 on the virtual machine.
a. Insert your Windows CD into your OmniTouch ACS server CD/DVD drive.
b. Return to your client workstation and locate the box labeled
c. Select the checkboxes labeled
d. Perform the following steps in quick succession.
Note:
............................................................................................................................................................................................................................................................
2 - 1 0 6
Document Conversion VM page. Enter the name or IP address of your client
workstation (
VNC Client IP
button in the resulting dialog box.
OK
TightVNC window, you
are not running a listener on your client workstation.
Or
have a firewall on your client workstation blocking the VNC connection.
the Construct Document Conversion VM page on the Web Administration page.
.
Manual Activation
i. Click the button on the Web Administration page and click
Start
resulting dialog box.
ii. Immediately switch to the TightVNC window page.
If there are errors, see Step iv below.
iii. A new VMware image should quickly appear – within 30 seconds. A window
reflecting activity on the virtual machine will appear within the new VMware
image.
iv. If you see errors, you may need to perform one of the following corrective
actions and start at step 3.c again.
A failure of the grab state – Cancel the warning dialog box to continue the
installation.
Insufficient virtual memory to start the virtual machine – Cancel the
warning dialog box and click the Power On button in the VMware window.
This operation may need to be repeated several times.
VMware window enters a loop where the hard disk options page appears
and is repeatedly closed – Wait for the loop to end – may take several
minutes. Close the VMware window (not TightVNC), and start at step 3.c
Step 2: Open VM Window
) and click the
Open
Initialize, Install Windows and Office
To construct document conversion VM
on the Construction of
button.
Step 3: option A
, and
OK
8AL90208USAD ed01
November 20, 2008
on
Enable
in the