Alcatel-Lucent OmniTouch Administration Manual page 116

System Configuration
............................................................................................................................................................................................................................................................
The settings are as follows:
SNMP Traps
Disable
– This setting uses SNMPv2 community. (no password needed)
V2c
– This setting uses SNMPv3. (Authentication password needed)
V3
SNMP Trap Host
sent to the host specified as the "SNMP Trap Host."
SNMP Engine Number
The engine number is specified in hex (for example, 0x0102030405). It is chosen by the
administrator, and must be the same on both the trap sending and trap receiving sides.
SNMP User
The SNMP security name is a text string without spaces. It is chosen by the administrator
and must be the same on both the trap sending and trap receiving sides.
SNMP Password
The SNMP password is a text string without spaces. Both the trap sending and trap
receiving sides must be configured to use the same password for the specified user.
SNMP Monitoring
Disable
V1/V2c
– This setting uses SNMPv3. (Authentication password needed)
V3
V3 w/Privacy
Authentication and Privacy)
SNMP System Location
user to aid in system location. The following special characters cannot be used:
" $ ' * < > ?| [ ] `
SNMP Community
SNMP that belong to a specific community (group). This name is required when running
SNMP V1/V2c.
SNMP User
SNMP . If SNMPv3 is running, the user needs an Authentication password. If SNMPv3
w/privacy is running, the user needs an Authentication password and a Privacy password.
............................................................................................................................................................................................................................................................
2 - 9 6
– This setting does not use SNMP for system monitoring. (default setting)
– The host name of the SNMP trap system. In all cases, the traps are
– The authoritative (security) engine ID for SNMP v3 requests.
– The SNMP v3 security name (uses MD5 authentication).
– The SNMP v3 security pass phrase and privacy pass phrase.
– This setting does not use SNMP for system monitoring. (default setting)
– This setting uses either SNMPv1 or SNMPv2 community. (no password needed)
– This setting uses SNMPv3 with privacy. (two passwords needed –
– This is an optional descriptive word or phrase supplied by the
– This is the name used to identify devices and stations running
– This is a single user who has rights to monitor network performance through
To configure the server to generate SNMP traps
8AL90208USAD ed01
November 20, 2008