Installing Devices In The Drive Bays - Intergraph InterServe 800 System Reference Manual

36
The following table provides the device locations and related information.
Location
12
11
10
9
8
7
6
5
4
3
2
1
NOTE If you are installing an additional EIDE device, you must mount the device in Location 9 or 10
and install an additional EIDE control cable due to cabling restrictions.

Installing Devices in the Drive Bays

NOTE Two internal bay drive brackets are installed in the chassis for mounting drives.
To install a drive in the external drive bay:
1. Turn off the ciruit breaker and remove the AC power cord from the system.
2. Remove both side panels.
3. Remove the four screws that secure the external bay disk drive tray to the chassis. There
are two hex head screws on the right side, and two phillips head screws on the left side.
Drive Peripheral Bay
Floppy drive External
EIDE CD-ROM External
Add-on device External
Add-on device External
Add-on disk drive Internal
Add-on disk drive Internal
Add-on disk drive Internal
Add-on disk drive Internal
Add-on disk drive Internal
Add-on disk drive Internal
Add-on disk drive Internal
System disk drive Internal
Max Bay Capacity
3.55-inch x 1.0-inch
5.25-inch x 1.6-inch
5.25-inch x 1.6-inch
5.25-inch x 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
3.5-inch x 1.0 or 1.6-inch
External Bay
Mounting Screws
(4)
SCSI ID
—
—
9 or EIDE
8 or EIDE
7
6
5
4
3
2
1
0