Product for High Safety Required Use, please consult with our sales representatives in charge before such use. FUJITSU and the FUJITSU logo are trademarks of Fujitsu Limited. UNIX is a registered trademark of The Open Group in the United States and other countries.
This online manual can be referred to either directly from the CD-ROM or copied to your hard disk. FUJITSU PCI GigabitEthernet 2.4 User's Guide You can refer to the above listed online manuals on a servers or a PC by using a Web browser that supports HTML3.2.
When you use the error notification function (addon function), please be sure to install Enhanced Support Facility before installing this package. 3) Exclusive software None. 4) Patch requirements By the application of this patch, the new function of FUJITSU PCI GigabitEthernet 2.4 is validated. Patch ID 912784-03 114536-12 114994-12...
110900-12 112838-11 118822-11 5) Unified Installer * Related Files Below files are included. The file path is from CD-ROM root. - ./.FJSVclis/Disk1/cdsetup - ./.FJSVclis/Product1/prodsetup - ./.FJSVclis/Product1/admin - ./.FJSVclis/Config1/I08FJSVgid.sh - ./.FJSVclis/Config1/FJSVgid_config_readme.txt : Readme file of the script to set the operating mode. - ./.FJSVclis/Config1/config/fjgi.sh * Precondition The files cdsetup and prodsetup are created in order to be called from the Unified installer.
/opt 3.3.2 Work area requirements None. 3.4 Dynamic Disk Resources None. 3.5 Memory Requirements The following table shows the memory required when you use this software for the following operations. Memory required (unit:megabytes) *This value shows required memory per a port.In Quad GigabitEthernet card(PW008QG1), about 36 megabytes memory size is required for a card.
(3) Install the card according to the installation instruction of the products that the card is installed. (4) Connect the power supply cord of the product to the supply or turn on the main line switch of the product. (5) Power the system on after confirming the proper installing in accordance with the installation instruction of the products.
/cdrom/cdrom0/FJSVgid_2.4/fjgi_q.dat /opt/FJSVcsl/etc/scsidata/fjgi_q.dat When you use GigabitEthernet on "SynfinityCluster" or "PRIMECLUSTER", please refer to "Appendix C.3 Note" in "FUJITSU PCI GigabitEthernet 2.4 User's Guide" for detailed information about the setting and notes. When the installation program is finished, the system must be rebooted.