Table of Contents
Advertisement
Setting the Address of Each Quad Input Manager Module
For each Quad Input Manager Module that is connected to LCDs, you will need to set
an address (similar to a unit ID) on the front of the Quad Input Manager Module.
Using the Quad Input Manager Module address adjustment tool, manually turn the
dial in the middle of the address selector to the letter you want to be identified with
the LCDs connected to this Quad Input Manager Module. It is important to note that
each module must be unique. So one Quad Input Manager Module needs to be A,
the next B, etc.
It is recommended that you set the addresses when the Quad Input Manager
Modules are turned on. This make it easier to see LEDs as you switch between
addresses. Once you have set the IDs how you want, it is recommended that you
power cycle all Quad Input Manager Modules.
Runco WindowWall Installation Guide
Use a address adjustment tool to
turn this dial to the letter you want
System Addresses
45
Advertisement
Table of Contents
