Installing LCD Tiles
The basic concept of installing LCD tiles in the wall is similar to installing brackets.
Start from the center of the wall and build out the first row. As you complete each
row, ensure the entire row is level.
Caution: It is important that you check communication between the LCD tiles as you
build each row! This will help minimize changes once your wall is fully installed.
Installing the First or Bottom Row
As you plug in and install each LCD tile, turn it on to verify it works properly and to
ensure that the position sensor is active. See step
information.
Note:
later.
1
2
3
Wearing the provided gloves will prevent smudges that would need to be cleaned
Remove the first LCD from the box that you want to install.
Remove the LCD from the bag and then remove the mylar sheet and tape from
the LCD tile.
Using two people, lift the LCD into place. Each person should put one hand on
the handle of the back of the display and one hand on the bottom of the display.
Runco WindowWall Installation Guide
Installing LCD Tiles
of this section for more
10
33