Output Shift; Input Shift; Ir Code Select - Runco PlasmaWall PL-61CX Owner's Operating Manual

Output Shift

The OUTPUT SHIFT function shifts the entire image (including sidebars) up, down left or right. When you are center-
ing the overall image, use output shift. If an image needs to be centered within the sidebars, use INPUT SHIFT (see
below).

Input Shift

The INPUT SHIFT function shifts the video signal before it is processed. This is very effective if using a source that
either is slightly out of phase or is otherwise off-center in relation to other sources. Examples of this include Satellite
TV signals, or the output of a TIVO recorder. (TIVO users may find that a black bar exists on the right side of the
image. If so, use INPUT SHIFT to move the image to the right).

IR Code Select

If the remote control loses its 'memory' as a result of weak or dead
batteries, it must be re-programmed for the PFP Controller's code set.
To reprogram the remote to the default IR Code Set, press the
PROGRAM button followed by 0,1,3. If you have set the Controller for
a different Code Set, enter that number instead of 0,1,3.
Note: Pressing Enter after typing in the code is not necessary.
To troubleshoot remote control problems, change the code by access-
ing the IR Code Set in the Installation Menu.IR Code Set allows the
installer to choose from one of four different sets of IR codes. If the
default code has commands that are conflicting other equipment, try
using one of the other code sets.
When IR CODE SET is selected in the menu, you will get four code set
options- 013, 215, 510 and 918. These numbers correspond to the
number that is programmed into the remote control itself. For example,
if you wish to use IR code set 510, you would first select '510 code set'
from the menu, then program the remote for code 510 (as described
above). You may also disable the IR receiver on the Controller all
together by selecting 'Deactivated'. In the event the Controller has
been reset, the IR code set will default to 013.
'Menu/Enter' invert allows the menu and enter buttons on the remote
to reverse their functions; if 'YES' is selected, the menu button will
become the enter button, and the enter button will become the menu
button. This affects the remote ONLY.
Program Buton
23
PWR
M
1 2 3
4 5 6
7 8 9
0
R
UNCO