Table of Contents
Advertisement
Servicing
When LCD tiles need to be accessed or removed, this can be accomplished without
removing other LCDs in the wall. Starting at the top of the wall, LCDs can be pulled
up and out to place them in service mode, allowing the LCDs below to be accessed.
Within each LCD tile, the simple interface board can be disconnected and replaced
using thumbscrews with access from either the front or the back of the wall. LCDs can
also be completely removed and replaced very quickly. Because of their streamlined
design, they weigh less than typical LCD displays and are more easily handled.
Caution: When is service mode, do not unplug the power cable while the LCD is still on.
Use the remote control to turn off the LCD and then unplug the power cable. If you unplug
the power cable when the LCD is still on, it could damage the LCD.
Runco WindowWall Installation Guide
137
Advertisement
Table of Contents
