Runco WindowWall Installation Manual page 150

< > buttons on the IR
remote move a slave
menu sequentially to
each display in the
display wall.
136
Auto Layout has been
performed.
Runco WindowWall Installation Guide
If Auto Layout has not been completed or had
errors, the menu will appear on each display
in address order (A1, A2,A3). If no display is
connected for a particular address, the menu
will "disappear". Press the arrow key again to
move it to the next one until it comes back.
You can see which display is being addressed
by watching the info pane on any display.
Once auto layout has been done, Quad
Modules that are not connected will be
ignored, so it will be helpful to attempt auto
layout even if the position sensors are not
working.