Table of Contents
Advertisement
Configuration Scenarios
Wall Configuration
Each display's wall configuration is set up automatically by the Quick Configure
setting. Wall Mode is turned on, the wall width and wall height is set to the width and
height of the Runco WindowWall, and each display's row and column are setting
according to its position.
Scenario 3: One Sub Wall and Individual Inputs
In this scenario, one input is spread over multiple LCDs, while the rest of the LCDs
display individual inputs. This scenario may be used in a control room, where each
display is monitoring a particular source, and at a command, one input may be
magnified for more detailed viewing. The size of the sub wall in this scenario does
not matter. The examples show a 2 x 2 sub wall in a 3 x 3 Runco WindowWall, but you
could also have a 3 x 5 sub wall in a 6 x 6 wall, or any other configuration. The
restriction is that there is only one sub wall in the Runco WindowWall. The other
displays are showing individual inputs.
Cabling
The cabling for this scenario is the same as for the Big Picture Scenario. The Quad
Input Manager Modules must be looped together by use of the Dual Link In and
Loop Out Connectors (see page 105 for an example). There is no restriction on which
displays are connected to which Quad Input Manager Modules but you will want to
cable them in an orderly fashion so it is easy for you to associate each input with a
particular Quad Input Manager Module.
Source Routing
There are no quick configure settings for this scenario. You will need to set up the
source routing and wall settings for each sub wall configuration and save those
settings to a slot. To set up source routing, use the
each Quad Input Manager Module. This menu has two parts, each of which gives a
different view of the same settings. If you use one part of the menu, the other will
automatically update. The following diagrams use only the lower part of the menu.
For simplicity, the rest of the menu is not shown.
In the following diagrams, the settings from the
shown on the side of the diagram and these menus will appear on display A1.
Wall Settings
Once the source is routed, you still need to tell each processor which portion of the
source to show. This is done in the
LCD that is displaying an individual source should have
that is part of a sub wall should have its height and width parameters set to the sub
wall height and width, and its unit row and column parameters set to the row and
column within that sub wall.
106
BIG PICTURE SETUP
Runco WindowWall Installation Guide
QUAD MODULE ROUTE
menu are
QUAD MODULE ROUTE
menu on each processor. An
turned off. An LCD
WALL MODE
menu for
Advertisement
Table of Contents
