Table of Contents
Advertisement
Installing LCD Tiles
11
12
13
14
15
16
17
38
For displays in the same row, make sure they are in a straight line using a digital
level. Use this level to ensure the displays are plumb (true vertically for both sides
and the front) and aligned from display to display. While the displays will be set
to a nominal position prior to shipment, you might need to make minor
adjustments, which are described in the following steps.
Each LCD tile will come from the factory in the nominal position. However, due to
installation and manufacture tolerances, adjustments to the module position
may be required.
Starting with the center display, make sure it is level/parallel with the brackets. If
it is not, use the y-axis adjusters to accomplish this. Leave the other adjusters in
their nominal positions.
Y-axis
adjuster
For the next display in the row, repeat steps
When the next display in the row is installed, use the y-axis adjuster to level the
display just as you did with the previous one.
If the displays are not level with each other, fine-tune the y-axis adjusters of the
last installed display until it is level with the rest of the displays in the row.
Adjust the z-axis corners of the last installed display until it is flush with the
display next to it.
Runco WindowWall Installation Guide
-
and then continue to step
1
11
.
15
Advertisement
Table of Contents
