Table of Contents
Advertisement
Source Routing
For each display that is part of a large sub wall, set each switch to Loop, and Use
External Loop.
Set the External Loop of the Quad Input Manager Module that contains the source
for a large sub wall to that source. Set the External Loop of all the other Quad Input
Manager Modules to Dual Link In. Note that the source for the sub wall must be in
the first Quad Input Manager Module unless you have looped the sub wall back on
itself.
Wall Settings
Set the height and width for each display within a sub wall to the height and width of
that sub wall and set the unit row and unit column as appropriate.
Understanding the Quad Module Route Menu
Each Quad Input Manager Module has five digital video inputs: inputs 1-4 and a Dual
Link loop input. Each module has four LCD connections and a Digital Loop out DVI
connector. Within each Quad Input Manager Module is a set of electronic switches
that allow video to flow from one of the inputs to one of the LCDs and to the Digital
Loop Out connector. The example below shows a pictorial representation of these
switches. Each circle in the drawing represents one switch. For each switch, you can
choose one of the input arrows to flow to the output of that switch which in turn may
flow to another switch or to one of the Quad Input Manager Module outputs.
Dual Link In
Digital 1
Digital 2
Digital 3
Digital 4
Note:
External Loop
Internal Loop
Representation of the Quad Input Manager Module video switches.
Runco WindowWall Installation Guide
Use Loop
Switch 1
Switch 2
Switch 3
Switch 4
Configuration Scenarios
Loop Out
LCD 1
LCD 2
LCD 3
LCD 4
117
Advertisement
Table of Contents
