Others Set Mode; Beep Sound - Icom IC-7600 Instruction Manual

■ Others set mode

Calibration Marker
Ths tem s used for a smple frequency check of the
transcever. (default: OFF)
See p. 147 for calbraton procedure.
NOTE: Turn the calbraton marker OFF after
checkng the frequency of the transcever.
Beep (Confirmation)
A beep sounds each tme a swtch s pushed to con-
frm t. Ths functon can be turned OFF for slent
operaton. (default: ON)
The beep output level can be set n the level set
mode. (p. 123)
Beep (Band Edge)
When you tune nto or out of an amateur band's
frequency range, a beep sounds. Ths functons
ndependently of the confrmaton beep settng (as
descrbed above).
The beep output level can be set n the level set
mode. (p. 123)
When "ON (User)" or "ON (User) & TX Lmt" s
selected, [BAND] appears n the dsplay above the
functon swtch (F-5). Up to 30 band edge frequen-
ces can be programmed n band edge screen. (See
the page 31 for programmng detals.)

Beep Sound

Sets the desred beep frequency wthn 500 to
2000 Hz n 10 Hz steps. (default: 1000 Hz)
RF/SQL Control
The [RF/SQL] control can be set as the RF/squelch
control (default), the squelch control only (RF gan
s fxed at maxmum) or 'Auto' (RF gan control n
SSB, CW, RTTY and PSK; squelch control n AM
and FM).
See pgs. 2, 33 for detals.
Quick Dualwatch
When ths tem s set to ON, pushng and holdng
[DUALWATCH] for 1 sec. sets the sub readout fre-
quency to the man readout
dualwatch operaton. (default: ON)
frequency, and actvates
OFF
• OFF : Calbraton marker OFF
• ON : Calbraton marker ON
ON
• OFF : Confrmaton beep OFF
• ON : Confrmaton beep ON
ON (Default)
• OFF : Band edge beep s OFF
• ON (Default) : When you tune nto or out of the
default amateur band's frequency
range, a beep sounds. (default)
• ON (User) : When you tune outsde of, or back nto
a user programmed amateur band's
frequency range, a beep sounds.
• ON (User) & TX Lmt
: When you tune outsde of, or back nto
a user programmed amateur band's
frequency range, a beep sounds.
Transmsson s also nhbted outsde
the programmed band.
1000Hz
RF+SQL
: [RF/SQL] control as RF gan control
• AUTO
n SSB, CW, RTTY and PSK; squelch
control n AM and FM
• SQL : [RF/SQL] control as squelch control
• RF+SQL : [RF/SQL] control as RF/squelch control
(default)
ON
• OFF : Quck dualwatch OFF
• ON : Quck dualwatch ON
☞ Contnued on the next page.
10
SET MODE
128
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21