Icom IC-7600 Instruction Manual page 16

1
PANEL DESCRIPTION
■ Front panel (contnued)
TIMER
POWER
TRANSMIT
TUNER
BAL
PHONES
ELEC-KEY
NB
AF RF/SQL
MIC
MIC GAIN RF POWER BK-IN DELAY KEY SPEED
$6 MEMORY UP/DOWN SWITCHES [∫]/[√] (p. 99)
➥ Push to select the desred memory channel.
• Memory channels can be selected n both the VFO
and memory modes.
➥ Push to drectly select the desred memory chan-
nel after pushng [F-INP ENT] and a memory
channel number.
$7 MEMORY WRITE SWITCH [MW] (p. 101)
Stores the selected readout frequency and operat-
ng mode nto the dsplayed memory channel when
pushed and held for 1 sec.
• Ths functon s avalable both n VFO and memory
modes.
$8 MEMO PAD-WRITE SWITCH [MP-W] (p. 104)
Programs the dsplayed readout frequency and op-
eratng mode nto a memo pad.
• The 5 most recent entres reman n memo pads.
• The memo pad capacty can be expanded from 5 to 10
n the Others set mode. (p. 132)
$9 MEMO PAD-READ SWITCH [MP-R] (p. 104)
Each push calls up a frequency and operatng
mode n a memo pad. The 5 (or 10) most recently
programmed frequences and operatng modes can
be recalled, startng from the most recent.
• The memo pad capacty can be expanded from 5 to 10
n the Others set mode. (p. 132)
9
T X RX
HF/50MHz TRANSCEIVER
MONITOR
NR
NR
F- 1 F- 2
SSB CW RTTY/PSK
$6
SPLIT LOCK
AUTO
F- 3 F- 4 F- 5 F- 6
TUNE
AM/FM FILTER EXIT/SET REC PLAY
VOICE MEMORY
%0 VFO/MEMORY SWITCH [VFO/MEMO]
➥ Swtches the selected readout operatng mode
between the VFO and memory when pushed.
(pgs. 26, 99)
➥ Transfers the memory contents to VFO when
pushed and held for 1 sec. (p. 102)
%1 QUICK TUNING SWITCH [TS]
➥ Turns the quck tunng step ON or OFF. (p. 29)
• Whle the quck tunng ndcator, "Z," s dsplayed
above the frequency dsplay, the frequency can be
changed n programmed kHz steps.
• 0.1, 1, 5, 9, 10, 12.5, 20 and 25 kHz steps are select-
able for each operatng mode ndependently.
➥ When the quck tunng step s ON, push and hold
for 1 sec. to select the quck tunng step set mode.
(p. 29)
➥ When the quck tunng step s OFF, push and
hold for 1 sec. to turn the 1 Hz tunng step ON or
OFF. (p. 30)
%2 AUDIO PEAK FILTER/TWIN PEAK FILTER
SWITCH [APF/TPF]
During CW mode operation (p. 39)
➥ Push to turn the audo peak filter ON or OFF.
• "
➥ When the audo peak filter s ON, push and hold
for 1 sec. to select the APF passband wdth be-
tween WIDE, MID and NAR or between 320,
160 and 80 Hz, dependng on APF type settng
(SOFT or SHARP).
During RTTY mode operation (p. 47)
➥ Push to turn the twn peak filter ON or OFF.
• "
• The ndcator on ths swtch lghts green when the
functon s actvated.
$7 $8 $9 %0 %1
1.8 3.5 7 TWIN-PBT
1 2 3
SPLIT
10 14 18
4 5 6
DUAL
WATCH 21 24 28
7 8 9
GENE 50 F-INP
CHANGE 0
ENT
MP-W MP-R
PBT - CLR NOTCH
MAIN
/SUB
NOTCH CW PITCH
M.SCOPE MW VFO/MEMO
XFC TS
RIT TX
RIT/ TX
SPEECH
LOCK
" appears when audo peak filter s n use.
" appears when twn peak filter s n use.
%2
APF/TPF
%3
%4
%5
CLEAR