Icom IC-7600 Instruction Manual page 19

i METER JACK [METER] (p. 19)
Outputs a sgnal showng receved sgnal strength,
transmt output power, VSWR, ALC, speech com-
presson, V or I level for external meter dsplay.
d d
o STRAIGHT KEY JACK [KEY] (p. 17)
Accepts a straght key or external electronc keyer
output usng a standard
• [ELEC-KEY] on the front panel can be used for a
straght key or external electronc keyer. Deactvate the
nternal electronc keyer n the keyer set mode. (p. 45)
!0 ACCESSORY SOCKET 2 [ACC 2]
!1 ACCESSORY SOCKET 1 [ACC 1]
Enable connecton of external equpment such as
a lnear amplfier, an automatc antenna selector/
tuner, a TNC for data communcatons, etc.
• See p. 24 for socket nformaton.
!2 TUNER CONTROL SOCKET [TUNER] (p. 18)
Accepts the control cable from an optonal AH-4
HF/50 MHz AUTOMATIC ANTENNA TUNER
!3 SEND CONTROL JACK [SEND] (p. 18)
Connects to ground when transmttng to control an
external unt, such as a non-Icom lnear amplfier.
NOTE: T/R control voltage and current must be
less than 16 V DC/0.5 A (or 250 V AC, 200 mA
wth MOSFET swtchng).
!4 ALC INPUT JACK [ALC] (p. 18)
Connects to the ALC output jack of a non-Icom ln-
ear amplfier.
⁄ nch plug.
1
4
(+)
(_)
.
PANEL DESCRIPTION
!5 RECEIVE ANTENNA OUT [RX ANT– OUT]
!6 RECEIVE ANTENNA IN [RX ANT– IN]
Located between the transmt/receve swtchng cr-
cut and recever's RF stage.
Connects an external unt, such as preamplfier or
RF filter, usng RCA connectors, f desred.
In ths case, the antenna connector must be se-
lected as "ANT 1/R" or "ANT 2/R." (p. 112)
• When no external unt s connected, "ANT 1" or "ANT 2"
must be selected.
Receiver
Transmit/Receive
switching circuit
Transmitter
!7 TRANSVERTER CONNECTOR [X-VERTER]
(p. 18)
External transverter nput/output connector.
Actvated by voltage appled to [ACC 2] pn 6, or
when the transverter functon s n use. (p. 24)
1
1
2
IN
3
[RX ANT]
OUT
4
5
ANT 6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
12