Icom IC-7600 Instruction Manual page 87

• Scanning during dualwatch
Scannng operates only for the man readout. To
operate the scan durng dualwatch, scan on the man
readout and use the sub readout for your QSO usng
both dualwatch and splt frequency operaton.
q Program the desred programmed scan edges n
the same amateur band. See p. 101 for program-
mng.
• If you plan to operate a ∂F scan, programmng the
scan edges may not be necessary.
w Push [SPLIT] to turn the splt frequency functon
ON.
• " " appears.
e Select VFO mode for the man readout.
r Set the desred operatng frequency for the man
readout.
t Push and hold [DUALWATCH] for 1 sec.
• " " appears.
• Equalzed receve frequency and operatng mode
appear on the sub band readout and the dualwatch
functon s turned ON.
y Push [SCAN] (F-5) to select the scan screen.
• Push [EXIT/SET] several tmes to close any mult-func-
ton screens, f necessary.
u Push [PROG] (F-1) or [∂F] (F-2) to start the pro-
grammed scan or ∂F scan, respectvely.
• Scan actvates on the man readout between the pro-
grammed scan edges or wthn the ∂F span.
• Transmttng on the sub readout stops the scan.
i To cancel the scan, push [EXIT/SET].
RECEIVE AND TRANSMIT
DUAL
SPLIT
WATCH
F-1 F-2 F-5 EXIT/SET
PROG ∂F SCAN
4
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
80