Advertisement
5 DATA USED FOR POSITIONING CONTROL
Da.14 Parameter
Set the value as required for "
Da.13
Special start instruction
Block start (Normal start)
Condition start
Wait start
Simultaneous start
Repeated start (FOR loop)
Repeated start (FOR condition)
Da.13
Special start instruction ".
Setting value
–
Not used. (There is no need to set.)
Set the condition data No. (No. of
"condition data" set to perform
condition judgment)
1 to 10
(For details of the condition data, refer
to Section 5.5.)
0 to 255
Set the No. of repetitions.
Set the condition data No. (No. of
"condition data" set to perform
condition judgment)
1 to 10
(For details of the condition data, refer
to Section 5.5.)
5 - 79
MELSEC-Q
Setting details
Advertisement
Troubleshooting
