HP Surestore 64 - Director Switch User Manual page 225

Table 9: Product Manager Messages (Continued)
Performing this
operation will change
the current state to
Online.
Periodic Date/Time
synchronization must
be cleared.
Port binding was
removed from attached
devices that are also
participating in Switch
Binding.
Port cannot swap to
itself.
Port diagnostics cannot
be performed on an
inactive port.
Port speeds cannot be
configured at a higher
rate than the director
speed.
Product Manager error
< error number 5001
or 5002 >.
Product Manager
instance is currently
open.
Director Product Manager User Guide
Message
This message requests
confirmation to set the
director online.
Action cannot be
performed because
Periodic Date/Time
Synchronization option
is active.
Informational
message. User has
removed Port Binding
from attached devices,
but one or more of
these devices is still
controlled by Fabric
Binding.
Port addresses entered
in the Swap Ports
dialog box are the
same.
This displays when
port diagnostics is run
on a port in an inactive
state.
This displays when you
configure a port to 2
Gb/sec and the
director speed is set to
1 Gb/sec.
The
application
encountered an
internal error (5001 or
5002) and cannot
continue operation.
A
window is currently
open.
Description
Product Manager
Product Manager
Information and Error Messages
Action
Click OK to set the director
online or click Cancel to cancel
the operation.
Click Periodic Date/Time
Synchronization check box in
Configure Date and Time
dialog box (Configure menu) to
clear check mark and disable
periodic date/time
synchronization.
Review the Switch Binding
Membership List to determine if
the devices should be members.
Ensure that address in the first
and second Port Address fields
are different.
Run the diagnostics on an
active port.
Set the director speed to 2
Gb/sec in the Configure Switch
Parameter dialog box.
Contact the next level of support
to report the problem.
Informational message only.
225