HP Surestore 64 - Director Switch User Manual page 213

Table 9: Product Manager Messages (Continued)
Cannot start data
collection.
Cannot start firmware
install while CTP
synchronization is in
progress.
Cannot start port
diagnostics.
Cannot swap an
uninstalled port.
Click OK to remove all
contents from log.
Connection to HAFM
server lost. Click OK to
exit application.
Continuing may
overwrite host
programming.
Continue?
Could not export log to
file.
Director Product Manager User Guide
Message
The data collection
procedure cannot be
started by the
Manager
because the Ethernet
link is down or busy.
The director's CTP
cards are
synchronizing and
firmware cannot be
installed until
synchronization is
complete.
Port diagnostics cannot
be started at the
Product Manager
application because
the Ethernet link is
down or busy.
A port swap cannot be
performed when the
port card is not
installed.
This action deletes all
contents from the
selected log.
The
at a remote
workstation lost the
network connection to
the HAFM server.
Configurations sent
from the host may be
overwritten by HAFM.
A log file I/O error
occurred and the file
could not be saved to
the specified
destination. The disk
may be full or write
protected.
Description
Product
application
HAFM
application
Information and Error Messages
Action
Retry the operation later. If the
condition persists, contact the
next level of support.
Install the firmware after CTP
card synchronization completes.
Retry the operation later. If the
condition persists, contact the
next level of support.
Perform a swap only on a port
that is installed.
Click OK to delete the log
contents or click Cancel to
cancel the operation.
HAFM
Start the application to
connect to the HAFM server.
Continuing will activate the
current configuration, which
may have been configured by
an FICON host.
Ensure file name and drive are
correct.
213