Modifying Alerts; Activating Or Deactivating Alerts - HP Surestore 64 - Director Switch User Manual

Fw 05.01.00 and sw 07.01.00 - director product manager - user guide
Hide thumbs Also See for Surestore 64 - Director Switch:
Table of Contents

Advertisement

Modifying Alerts

Use the following steps to modify an existing threshold alert configuration.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
2. If the alert is active, click Deactivate, then choose the alert information in the
3. Click Modify. An initial Modify Threshold screen displays where you can
4. Select a threshold type from the drop-down list.
5. Click Next when you are done. A Modify Threshold screen displays where
6. Make appropriate changes, then continue through the Modify Threshold
7. Perform either of the following steps:

Activating or Deactivating Alerts

Use the following steps to activate or deactivate existing threshold alerts. In the
active state, notifications are generated for the alert. In the inactive state,
notifications do not occur.
1. At the Hardware View page, choose Configure > Threshold Alerts. The
2. To change the state, choose the alert by the alert information in the table.
3. If the alert is active, choose Deactivate to change to the inactive state. If the
Director Product Manager User Guide
Configure Threshold Alerts dialog box displays.
Choose the alert that you want to modify when you click the alert information
in the table. If the alert is active, an error message displays prompting you to
deactivate the alert.
table again.
change the threshold type.
you can change the % utilization, cumulative minutes for the threshold to
occur before notification, and the time interval for measuring throughput and
for alert notification.
screens, making changes as necessary, until the summary screen displays the
alert configuration.
If you need to change any parameters, click Previous or Next to display
the desired Modify Threshold screen.
Click Finish when you are done.
Configure Threshold Alerts dialog box displays.
The port's current state, inactive or active, is listed under the State column.
alert is inactive, choose Activate to change to the active state.
Configuring the Director
153

Advertisement

Table of Contents
loading

This manual is also suitable for:

Director 2/64Director 2/140

Table of Contents