HP Surestore 64 - Director Switch User Manual page 211

Table 9: Product Manager Messages (Continued)
Cannot run diagnostics
on a port card that is
not installed.
Cannot run diagnostics
while a device is
logged-in to the port.
Cannot save IPL
configuration while
active=saved is
enabled.
Cannot save port
configuration.
Cannot save SNMP
configuration.
Cannot set all ports to
1 Gb/sec due to speed
restriction on some
ports.
Director Product Manager User Guide
Message
Port diagnostics
(loopback tests) cannot
be performed on a
port that does not have
a small form factor
(SFF) optical
transceiver installed.
Port diagnostics
(internal loopback test)
cannot be performed
on a port while an
attached Fibre Channel
device is logged in.
The user cannot save
the IPL file while the
active=saved property
is set.
The port configuration
cannot be saved at the
Product Manager
application because
the Ethernet link is
down or busy.
The director SNMP
configuration cannot
be saved at the
Manager
because the Ethernet
link is down or busy.
Displays if you try to
set ports to operate at
1 Gb/sec data speed
through the Configure
Ports dialog box and
some ports do not
support speed
configuration.
Description
Install a transceiver in the port
and perform diagnostics again.
Ensure the device is logged out
and perform diagnostics again.
The FICON management server
property, active=save, must be
disabled for HAFM to save the
IPL file.
Retry the operation later. If the
condition persists, contact the
next level of support.
Retry the operation later. If the
condition persists, contact the
Product
next level of support.
application
Replace ports that do not
support speed configuration
with those that do support more
than one configuration.
Information and Error Messages
Action
211