Installation Wizard For Windows Users; Running The Installation Wizard - HP StorageWorks D2D100 - Backup System User Manual

Installation wizard for Windows users

For Windows users, the recommended way to set up the HP D2D Backup System network is to run the
Installation wizard from the HP StorageWorks D2D Backup System CD-ROM, particularly if you are
configuring the host for the first time.
The HP D2D Backup System can be used to back up a maximum of six hosts. You should run the
Installation wizard on each host that will provide a source of data for backup. The wizard configures the
software components needed to connect from the host and use the HP D2D Backup System. The host
may be a server, workstation or PC.

Running the Installation wizard

NOTE:
You must have the necessary administrative rights on the host to run the Installation wizard successfully
and the host should be connected to the Internet in case it is necessary to download the Microsoft
iSCSI Initiator.
1.
Insert the CD-ROM supplied with your HP D2D Backup System into the host machine. It should launch
automatically. If it does not, locate the D2DInstallationWizard.exe file and run it manually.
2. Select Start the wizard and follow the onscreen instructions to step through the installation, normally
by pressing Next.
The Installation wizard will, if possible, configure all the software components required for setup and
use of the HP D2D Backup System. Use the Wizard help if you need more information.
• Install drivers: These allow your system to recognize the tape medium changer and drive
devices created on the HP D2D Backup System.
• Discover network devices: This allows you to locate your HP D2D Backup System on the
network and configure network settings. If you have multiple devices on your network, a list
is displayed so that you can select the required HP D2D Backup System.
D2D Backup System HP D2D2503
35