Powering On The Hp D2D; Software Installation, Discovery And Configuration; Connecting To A Dedicated Backup Network; Powering On The Hp D2D Backup System - HP StorageWorks D2D100 - Backup System User Manual

Server
Supplied cable
Figure 13 Connecting to a dedicated backup network

Powering on the HP D2D

Press the Power on button on the front of your HP D2D Backup System. The normal boot sequence
takes approximately 2 minutes. On power up the HP D2D Backup System runs its fans at high speed
for approximately 10 seconds before returning to normal speed.
Figure 14 Powering on the HP D2D Backup System
1. Power On button
Software installation, discovery and configuration
There are three stages to installation:
• Install all the required drivers
• Discover and configure the HP D2D Backup System on the network
• Create a base configuration to get started
UNIX and Linux users should download the latest patches for their operating system and refer to the
"Linux and UNIX Configuration Guide" on the HP StorageWorks D2D Backup System CD-ROM for
configuration instructions.
34
Connecting and installing the HP D2D Backup System
Server
Switch
Storage Network
HP StorageWorks D2D
Backup System
Server
LAN