Email Alerts And Log; If You Have A System Console; Raid Rebuilding - HP StorageWorks D2D100 - Backup System User Manual
Hp storageworks d2d backup system (hp d2d2503) user guide (eh990-90905, december 2008)
Hide thumbs
Also See for StorageWorks D2D100 - Backup System:
- Release note (4 pages) ,
- User manual (41 pages) ,
- User manual (144 pages)
Table of Contents
Advertisement
16.
After the unit has powered up, log in to the Web Management Interface and select RAID. The status
of the failed disk should now be OK. The RAID will rebuild automatically but can take up to 5 hours.
The RAID Status section displays the Percentage Complete.
Figure 71 RAID rebuilding
Email alerts and Log
If you have configured recipients for email alerts on the Web Management Interface, they will be notified
that the RAID is being rebuilt and when the rebuild has completed.
The Log also contains an entry when the RAID rebuild completes.
If you have a system console
If you have connected a system console, as described in
the disks are shown as OK, but a message is displayed against the RAID Status Level while the RAID is
rebuilding.
168
Hard disk replacement
"To connect a system
console" on page 47,
Advertisement
Table of Contents
