HP StorageWorks D2D100 - Backup System User Manual page 72

6. Select a Target Appliance from the list and click Next.
NOTE:
If you want to select an appliance that is not yet on the list, click Add Target Appliance.
Enter the Target Appliance IP Address or fully qualified domain name. The default values
for the Command and Data Protocol Port Numbers are usually acceptable, but may be
edited if there is a conflict. Click Add Target Appliance.
7. The wizard then moves to the Select Target Library step. Select a library on the target appliance
and click Next.
NOTE:
If you need to create a new library on the target appliance, click Create New Target
Library. Set up the details as you would normally do when creating a new library device, see
"To create a new device" on page 92.
72
Configuring and using replication