Reverse Replication Process: Source Lost, Mapping Deleted - HP StorageWorks D2D100 - Backup System User Manual

Start
Create non-replicating library on new source appliance.
Use physical
tape media to
'reverse seed'?
Yes
Tape Attach:
1. Use Tape Attach on target appliance to copy last
full backup cartridge to tape.
2. Transport physical tape to replication source site.
3. Use Tape Attach to import physical tape to newly
created library on the source appliance.
On the Mapping Configuration page select the new
non-replicating library on the source appliance.
1. Select Start Replication Wizard. (Do not use the
Recovery Wizard.)
2. Add IP address or FQDN of the target appliance
that was used as previous replication target.
3. Select existing library to use for recovery.
(Its status is now non-replicating, not target.)
4. Remap the slots that were used in the previous
configured slot mapping.
5. Unhide the Recovering checkbox column and
select the cartridges to be recovered. (Any not
selected will not be recovered, but will be used
for subsequent replication overwrite.)
6. Select Apply to start reverse replication.
As soon as reverse replication has completed for each
slot use original backup application to recover data to
the host.
New backups to the source device and replication can
now run normally.
End
Figure 47 Reverse replication process: source lost, mapping deleted
1.
Create a new Non-Replicating Library on the Source Appliance (either by running the Installation
wizard or by using the Devices page).
78
Configuring and using replication
No