About The Spf; Originals That Can Be Used - Sharp AR-FX4 Operation Manual

ABOUT THE SPF

If a SPF is installed, you can load multiple sheet originals (up to the sheet limit) in the SPF. The
originals will be automatically scanned one-by-one into memory. As there is need to load each sheet
manually, this saves times when faxing multi-page originals.
If the optional RSPF is installed, two-sided originals can be automatically scanned into memory. (See
page 106)

Originals that can be Used

Thickness and weight of originals that can be loaded in the SPF
The weight of originals that can be loaded in the SPF is 15 to 24 lbs. A maximum of 30 pages can be
loaded if the pages are all the same size and the maximum stack thickness is not exceeded.
If you load a long original, the original must be in direct contact with the tray (no other pages under it).
Otherwise, the wrong original size may be detected.
Important
G
Be sure to use originals that are of standard size and weight (thickness). Non-standard
originals may jam.
G
Remove any clips and staples from originals before loading them.
G
Make sure that any glue, ink, or correcting fluid on an original has dried completely before
loading the original. Otherwise, the inside of the machine and scanning glass may be soiled.
G
Load an original with file-binding holes (two-holed or three-holed originals) so that the side with
the holes enters the feeder first as shown below, or so that the side with holes is aligned along
the original guides.
Originals that cannot be used
The following originals cannot be loaded. These originals may misfeed.
G
Transparent or semi-transparent originals such as overhead projector film, transparencies, or
photographs.
G
Carbon paper, thermal paper.
G
Paper with large creases or folds, curled paper.
G
Sheets glued together, or cut-out paper.
G
Originals with numerous file-binding holes (two-holed or three-holed originals can be used).
G
Originals printed with an ink ribbon (thermal transfer) or originals printed on thermal transfer paper.
20
15- to 24-lb. paper and maximum
stack thickness of 5/32"
5/32" max.
Position of holes