Sharp AR-FX4 Operation Manual page 158

USING KEY OPERATOR PROGRAMS
3
Press the
G
The setting is turned on and a checkmark appears in the checkbox in the message
screen.
G
If this procedure is performed when the setting is turned on, the checkmark is cleared
and the setting turns off.
Note
G
When a fax is sent by memory transmission, the page number and total number of pages
appear at the top of each fax page. When a fax is sent by Quick On-line transmission or direct
transmission, only the page number appears.
Send Mode
This setting is used to select whether the standard mode for sending faxes is memory transmission or
direct transmission. The initial setting is "memory transmission".
1 Follow steps 1 through 4 of the initial procedure. (See page 143)
2
Press the
3
Press the
4
Press the
then press the OK key.
Quick On Line Transmission
When the send mode is set to memory transmission, this setting determines whether normal memory
transmission or Quick On Line transmission is performed.
The initial setting is Quick On Line transmission.
1
Follow steps 1 through 4 of the initial procedure. (See page 143)
2
Press the
3
Press the
G
The setting is turned on and a checkmark appears in the checkbox in the message
screen.
G
If this procedure is performed when the setting is turned on, the checkmark is cleared
and the setting turns off.
Print Station Number in Received Data
This setting is used to select the position of the date and sender information that is printed at the top of
transmitted fax pages. If outside the original is selected, the information is added above and outside the
scanned original image, and thus the overall length is greater than the length of the transmitted original
image. If inside the image is selected, the information is added at the top and within the scanned original
image, and thus the overall length is the same as the transmitted original image; however, part of the top
of the transmitted original may be cut off. The initial setting is outside the original.
1
Follow steps 1 through 4 of the initial procedure. (See page 143)
154
or key to select "PAGE COUNTER SET" and then press the OK key.
or key to select "SENDING FUNCTION" and then press the OK key.
or key to select "SEND MODE" and then press the OK key.
or key to select "MEMORY TX" or "DIRECT TX", and
or key to select "SENDING FUNCTION" and then press the OK key.
or key to select "QUICK ON LINE TX" and then press the OK key.