Sharp AR-FX4 Operation Manual page 145

Setting Program name
SENDING PAGE COUNTER
FUNCTION SET
SEND MODE
QUICK ON LINE TX When the send mode is set to memory transmission, this setting
PRINT STATION #
IN RCVD DATA
ACC. NAME PRINT When using ACC mode, this setting determines whether or not
RECALL SETTING
(BUSY)
RECALL SET(ERR)
# OF RINGS AUTO
TX
AUTO COVER
SHEET
RCV. FUNCTION #OF RINGS AT. RX
TRAY SELECTION
RECEIVED DATA
PRINT CONDITION
AUTO RCV
REDUCE TO
REGULAR SIZE
A3 RX REDUCE
FW. RX DATA
RECEIVED DATA
FW. STATION SET
INDEX PRINT
EARLIER OUTPUT
ANTI JUNK FAX
ENTER JUNK FAX # This setting is used to program numbers from which you wish to
KEY OPERATOR PROGRAM LIST
Program function (description)
This setting is used to select whether page numbers are printed
at the top of transmitted fax pages.
This setting is used to select whether the standard mode for
sending faxes is memory transmission or direct transmission.
determines whether normal memory transmission or Quick On
Line transmission is performed.
This setting is used to select the position of the date and sender
information that is printed at the top of transmitted fax pages.
the recipient is notified of the sender's ACC name when a fax is
sent.
When you attempt to send a fax and the line of the receiving
machine is busy, your machine will automatically re-attempt the
call. This setting is used to select the number of recall attempts
that will be made and the interval between attempts.
This setting is used to select the number of recall attempts that
will be made and the interval between attempts when a
transmission is not successful due to a line error.
This setting is used to set the time limit for the other machine to
respond when your machine attempts to send a fax by
automatic dialing. If there is no response within the time limit,
your machine automatically breaks the connection.
This setting is used to have a cover sheet automatically
included with each fax transmission.
This setting is used to select the number of rings the machine
waits before answering in automatic reception mode.
This setting is used to select which output trays can be used for
received faxes.
This setting is used to select how a received fax should be
printed when the machine does not have the same size of paper
as the received image. The fax can be either reduced or divided
before printing.
This setting is used to select automatic reduction to the set
paper size of the paper tray when you receive a non-standard
size fax that is larger than your paper.
This setting is used to select automatic reduction of received A3
faxes before printing.
When your machine receives a fax to memory because it is
unable to print, this setting is used to select automatic
forwarding of the fax to a destination stored using this program.
This setting is used to store the destination fax number for
forwarding faxes received to memory.
This setting is used to have a black mark (index) printed at the
top of each received fax.
When a received fax cannot be printed because the machine is
out of appropriate paper and a fax is subsequently received that
can be printed, this setting determines whether the subsequent
fax is printed before the fax that cannot be printed.
This setting is used to block reception of faxes from specified
fax numbers.
block fax reception.
Page
153
154
154
154
155
155
156
156
157
157
158
158
159
159
159
160
160
161
161
161
141