Sharp AR-FX4 Operation Manual page 171

Sub-Address Relay Group Set
This setting is used to program a memory box for relay broadcast of received data upon receipt of a sub-
address relay request. A sub-address and passcode for reception of a sub-address relay request and
the destinations to which the data is to be relayed are programmed for each box. Up to 10 boxes can be
programmed, and the programmed boxes can be checked in the "SUB ADD SET LIST". (See page 144)
1
Follow steps 1 through 4 of the initial procedure. (See page 143)
2 Press the
3
Press the
and then press the OK key.
4
Press the
5
Press the
group that you wish to program, and then press the OK key.
6
Enter a name for the group (up to 36 characters) and then press the
OK key.
G
To enter characters, see "ENTERING CHARACTERS" on page 63.
7
Program a sub-address and passcode. (See steps 2 and 3 pages 52, 53)
G
Numbers from 0 to 9 can be entered for the sub-address. Numbers from 0 to 9, as well as
"#" and " ", can be entered for the passcode.
G
If you make a mistake, press the CLEAR key and then re-enter the correct number.
8
Specify the destinations. (See page 77)
Note
G
To clear a sub-address relay group, follow these steps:
(1) Select "DELETE" in step 4 and then press the OK key.
(2) Press the or
clear, and then press the OK key.
(3) Press the or
Sub-Address Memory Polling
This setting is used to program a sub-address memory polling box to store document data for remote
transmission when polled by a machine that supports sub-address communication. The programmed
box can be checked in the "SUB ADD SET LIST". (See page 144)
1
Follow steps 1 through 4 of the initial procedure. (See page 143)
2
Press the
or key to select "SPECIAL FUNCTION" and then press the OK key.
or key to select "SUB ADDRESS RELAY GROUP SET"
or key to select "NEW REGISTRATION" and then press the OK key.
or key to highlight the unused sub-address relay
key to select the name of the sub-address relay group that you wish to
key to select "DELETE" and then press the OK key.
or key to select "SPECIAL FUNCTION" and then press the OK key.
USING KEY OPERATOR PROGRAMS
167