Installing Your Newunit; Basic Connections - JVC DR-M10 Instructions Manual

18 EN INSTALLING YOUR NEW UNIT
Basic C onnections
It's essential that your unit be properly connected.
THESE STEPS MUST BE COMPLETED BEFORE ANY
VIDEO OPERATION CAN BE PERFORMED.
Check lhe c0nlenls.
Make sure the package contains all of the accessories
listed in "SPECIFICAYIONS" on page 109.
F_ Install t heunit.
Place the unit on a stable, horizontal surface.
ANTENNA
OUT
I
I
I
I
Audio/video cable
(supplied)
_,Fcable
(supplied)
Antenna or Cable
Coaxial cable ]
._ :Flat feeder
Matching transformer
(not supplied)
AUDIO/VIDEO AC Outlet
OUTPUT T
AC Power Cord
To 75 ohm
Terminal
]b Audio/video
input connectors
TV
I_1 Connect t heunit to a TV.
[] Disconnect the TV antenna from the IV.
[] Connect the TV antenna cable to the ANTENNA IN
connector on the rear panel of the unit.
[] Connect the supplied RF cable between the
ANTENNA OUT connector on the rear panel of the
unit and the TV's antenna connector.
[] Connect the supplied audio/video cable between the
AUDIO/VIDEO OUTPUT connectors on the rear
panel of the unit and the TV's audio/video input
connectors.
• Set your TV to AV mode.
• For switching the TV's
mode,
refer to the instruction manual of
your TV.
Connect t heunit to power source.
Plug the end of the AC power cord into an AC outlet. This
unit performs Plug & Play Set automatically. (_-_" pg. 21 )
• The clock and tuner channels will automatically be set when
the antenna is connected and when the AC power cord is first
connected to an AC outlet. (If "AUTO" and the channel
indicator are displayed on the front display panel before the
unit is powered on, the clock an(] tuner channels are being set
automatkally, Wait for the time to be displayed on the front
display panel before turning on the unit,)
NOTES:
• It requires the RF (-onne(tion to enjoy TV programs.
• The playback image is not displayed without one of the
following: A/V, S-Video, or Component Video connection.