JVC DR-MV77S Faq

Thank you for your purchase of the JVC DR-MV77SU/78BU DVD Video Recorder.
If you have any questions regarding the hookup or operation of your DR-MV77SU/78BU, please contact
our Customer Care Center at 1-800-252-5722.
Please Note:
Be sure to connect the AC power plug into the power outlet after all other connections are completed.
What DVDs can I use to record on my
DR-MV77SU/78BU?
c DVD-R, DVD+R, DVD-RW and DVD+RW can be
used to record on your DR-MV77SU/78BU.
DVD-RAM will not be recognized as recordable
media on your DR-MV77SU/78BU.
For recommended recordable DVD discs, please
refer to page 7 in your owner's manual.
When I turn on my DR-MV77SU/78BU, it
flashes "Hello" and all the buttons on the
remote control and the front panel will not
respond for 10 - 15 seconds. Is this normal?
When your DR-MV77SU/78BU is first turned on, it
will flash "Hello" as the internal EPROM chip is
updated with information.
c Please wait until "Hello" stops flashing before you
attempt to use the remote control or front panel
buttons. It takes 25-30 seconds until the set
can be operated when a disc is on the tray.
My DR-MV77SU/78BU is showing a distort-
ed picture.
Your DR-MV77SU/78BU has a progressive scan fea-
ture. This feature only works with a TV that accepts a
progressive scan signal.
c If the picture is distorted, press OUTPUT
STATUS button and select 480i.
For additional troubleshooting tips please refer to pages 47-49 in your owners manual.
JVC Customer Care Center
1-800-252-5722
DR-MV77SU/78BU Quick Guide FAQ's
My DR-MV77SU/78BU is showing no picture.
There is no signal output other than HDMI when
HDMI is connected and 720p/1080i is selected at
OUTPUT STATUS.
c Press OUTPUT STATUS button and select either
480i or 480p in order to watch the video signal
from AV OUT, S-VIDEO OUT, COMPONENT/
PROGRESSIVE SCAN VIDEO OUT.
My newly recorded DVD plays in my
DR-MV77SU/78BU but does not play in
other DVD players.
c You must "Finalize" the DVD before it can play in
another DVD player.
Please see page 21 in your owner's manual.
During the Initial Set Up, I am being asked
to set the Clock. Does this model have Auto
Clock Set?
c Because of the new Tuner-Free design, this unit
doesn't have an Auto Clock Setting. You will need
to manually set your clock as shown on page 17
of your owner's manual under the Initial Setup
Wizard. You can also look on page 18 of your
owner's manual and follow the directions for
Clock Set.
How can I record TV program? How can I
use Timer-Link function?
As this model has a new Tuner-Free design, you
need to connect an external tuner such as
Cable/Satellite box. If your Cable/Satellite box has a
programmable ON/OFF timer function, the recording
will start/stop at the programmed time (Timer-Link
function).
See page 34 of your owner's manual for instructions
on how to use Timer-Link.
LPT1152-003A
0307MNH-OT-OT